Why Nobody Cares About Peugeot 308 Key Fob
Peugeot 308 Key Fob Replacement
Peugeot's 308 is a little old however it's still eye-catching. It's not the most luxurious car in its class, but it's a pleasant and peaceful drive.
Here at Coded Car Keys we are often asked to replace peugeot 308 key fobs. The following suggestions will assist whether the issue is intermittent, or constant.
Water Damage
If you leave your key fob in a puddle or get it wet during kayaking, swimming, canoeing, rafting, or canyoning, it's probably to be damaged by water. Keep your key fob in a dry bag every time you go outdoors or do activities that could expose it to a lot of water.
It's also essential to make sure the fob has completely dried before you open it to use it again. If you notice any smells emanating from the fob (such as industrial liquid or windshield washer fluid) it is a indicator that it is submerged.
A circuit board that is wet could cause the battery to dump its energy or even explode. If you're able to fish your 308 key fob out of the water body it was stuck in, flip the button side down and shake out as much water as possible before opening the case. Remove the battery, then wipe the circuit board down using a cotton swab that has been dipped in 90-percent alcohol.
Other reasons that your Peugeot 308 remote entry keyless system might not work could be due to a dead coin-cell battery or receiver module issue signal interference or a damaged chip. If none of the above are the problem, you can try resetting the system by disconnecting the battery with 12 volts for about 15 minutes.
Dead Coin Battery
Peugeot cars come with a remote-start system which allows the driver to start the car from afar, warming up or cooling down the vehicle prior to stepping inside. This feature is extremely helpful, especially during cold winter months. However, it is possible that the remote start system ceases operating due to a range of reasons, like the battery of a coin that is dead.
A coin-shaped battery found inside the key fob has a lifespan of two to four years, based on how often it is used and where it is purchased. The use-by date will be written on the packaging or marked in the user manual.
If the key fob stops working after being exposed to water that is clean, remove the battery and clean the electronic chip using an absorbent paper towel that has been soaked in isopropyl ethanol. Then dry the chip completely before replacing it. In the event of exposure to soapy or salty water, the chip could be damaged and you'll require replacing the key for peugeot 207 fob in total.
If you're not sure the battery is defective it is possible to test the voltage with an instrument set to the vehicle's voltage range and connected to the minus and plus terminals. If the voltage is lower than 12-13 volts then you need to replace the battery. You can also reset the computer that is onboard by disconnecting and reconnecting the 12 volt batteries in reverse order. (positive cable first, then negative cable). The engine should now start.
Faulty Receiver Module
If you don't see the "Key Detected" you might find the receiver module defective. It's the part that sends an alert to the car when the key fob is activated, which acts as an immobiliser. It stops it from starting unless the key that you want to use is present.
This could be due to a variety of reasons, including water damage or simply aging. If the electronic chip within your peugeot 107 spare key 308 keyfob is damaged by dirty tap water It could be because the keyfob was in contact with it. In this instance, you'll have to remove it and thoroughly clean it with isopropyl or an electronic cleaner. Once the battery is dry you can attempt to test it again.
If the problem persists it is a good idea that you visit a local peugeot 5008 key (visit this web page link) expert or locksmith. They'll be able to use a diagnostic tool to identify the problem and fix it.
Losing your Peugeot car keys can be an incredibly stressful experience. However, a professional auto locksmith can solve the problem in minutes. They can program your vehicle and cut a new, working key for you. Click here to find a locksmith near you.
Faulty Electronic Chip
The chip inside the Peugeot 308 key fob is a very crucial component of the remote control system. If the chip is damaged, you could be unable to start your car or receive a message stating "anti-theft". If this happens, the only way to fix the problem is to purchase a new key. Professional auto locksmiths can provide this service in the shortest time.
The chip inside the key fob of your Peugeot 308 may become faulty for many reasons, such as sweat, water damage, or dirt. If your Peugeot key fob has been exposed to dirty or soapy water, it should be cleaned immediately. You can use a paper towel and isopropyl ethanol to clean the electronic component. After that, allow the battery to completely dry.
Sometimes, a key fob can cease to function due to radio interference. This can happen when other devices use the same frequency as your Peugeot keyfob. This could be due to poor conditions or objects within the vicinity of the vehicle. It is recommended to visit a Peugeot dealer if you encounter this problem.
The Peugeot key fob 207/308 is very delicate and requires extra attention. You shouldn't drop it or throw it around. If you lose something, try to find it as quickly as you can. You can reset the onboard computer by disconnection of the battery for a few minutes. Make sure you disconnect the negative cable first before connecting the positive.