What Experts In The Field Want You To Know
Peugeot 208 Key Replacement
Peugeot 208 key replacement should be left to experienced auto locksmiths who have the appropriate equipment and know-how. They can design and program keys more quickly and at a lower cost than dealers.
A dead coin battery is the most likely cause the reason your key-fob stops locking or unlocking the doors. But, there are other reasons that the key may be malfunctioning.
Dead Coin Battery
A dead battery can stop your Peugeot 208 from locking and unlocking, as well as making it impossible to start the engine. If this is the scenario, you'll need apply the backup starting technique that is detailed in the owner's manual for your vehicle.
The spark plugs can also be worn out. The spark plugs are responsible for igniting the fuel that powers the engine. They only last for a certain amount of time. They'll eventually break down if they're not used enough.
Fortunately, there's an easy solution for this issue. The best solution is to test the voltage of your car battery using a multimeter. If it's lower than 11.5 volts, then you need to replace it. It is also necessary to clean the battery's contacts when it has corrosion. You can do this by lifting the rubber covers that protect the two terminals on the battery and using a wire brush to remove any corroded areas of the battery. Then, you must reconnect the positive pole cables to the negative.
Water Damage
If your 208 won't start and the battery has not gone flat, you should inspect the spark plugs. You might find that they are simply too dirty and don't spark. This is easily fixed by cleaning the spark plugs in a workshop.
Peugeot automobiles use a key with a transponder that is compatible with the immobiliser. This guarantees that only the right key can turn the engine. If the chip inside the Peugeot key is damaged, it will not transmit the proper signal to the vehicle.
This is a very common issue that can occur due to water damage. This is a frequent issue in colder climates where the vehicle is exposed to snow or rain. In this case, contact a reliable locksmith who will have the necessary tools and equipment to reprogram the key. They will also have the most up-to-date technological know-how and the equipment required to create the Peugeot 208 smart key. The process should take no more than 15 minutes.
Faulty Battery Contacts
peugeot 308 Replacement key changed from the old carbon encased transponder chips and introduced a new type of chip that uses electronic components within a circuit board. The new system is great when it's new, however the circuit boards wear out over time and stop working properly.
This can stop the immobiliser from triggering so that the vehicle won't start. If this is the case, it's a good idea get in touch with a Peugeot specialist or locksmith.
A common issue is when the battery inside the key fob starts to die. This causes the blade of the key to stop feeding into the lock. A locksmith in your car can replace the battery and cut a fresh blade for you, this is typically a quick fix.
Faulty Receiver Module
If your Peugeot key fob was not working after dropping it on the floor, getting exposed to a sudden rain or accidently washing it the wrong way, it could be due to a faulty receiver module. The receiver is responsible for sending radio frequency signals to the on-board computer, which is responsible for controlling the centralized locking system in your Peugeot vehicle.
Rubber seals on the key fob block water from getting to the electronic chip. However prolonged exposure to water can penetrate these seals and damage the chip. The high salt content in the pool or ocean water can cause damage to the key fob, especially if it is submerged.
The module must be replaced if your Peugeot spare key does not work anymore. This can only be completed by an experienced auto locksmith or Peugeot specialist. peugeot 207 remote key programming keys unlike other automobiles, are secured by an immobilizer device. This requires the correct programming to allow the car to start. This is the reason that you should only rely on the Peugeot locksmith to create and program the replacement.
Computers with faulty on-board computers
The computer on board of your Peugeot is responsible many features in your car, including power windows and airbags. If something is wrong with these systems, it'll typically display a code indicating the issue. This code is saved in the system and remains there until the issue has been resolved. Often, this will involve replacing the onboard computer.
One of the most common causes of the airbag light turning on is the loose or corroded connection in the airbag sensor. This can be caused by wear and tear, age or exposure to moisture and salt. This issue must be dealt with as soon as you can, since an airbag that is malfunctioning could be dangerous in case in the event of an accident.
If your Peugeot is showing a card detected as not present error then the key battery inside the key fob could be dead or weak. This prevents the key fob from sending a signal that disarms the standard immobilizer in your vehicle. Test this by pressing the unlock button on the fob's key and then trying to start your vehicle. If this doesn't work then the battery in the key will need replacing.