The 10 Most Terrifying Things About Peugeot 308 Key Fob
peugeot key fob not working 308 Key Fob replacement key for peugeot 308
Peugeot's 308 may be catching on a little, but it still feels appealing. It might not be the plushest car in its class - it's a Ford Focus or Volkswagen Golf will help you stay away from sloping surfaces - but it's still a pleasant and a civilized drive.
Here at Coded Car Keys we are often asked to replace peugeot 308 key fobs. No matter if the issue is intermittent or constant the following suggestions should assist.
Water Damage
If you accidentally drop your key fob in an eddy, or it gets wet while kayaking, canoeing, rafting or canyoning it is likely to be damaged by water. The best method to prevent this from happening is to always keep it in a dry bag when you're outside or performing activities in which the fob may be exposed to excessive amounts of water.
It's also essential to make sure the fob has completely dried before you open it and use it again. If you notice any odors coming from the fob, such as an industrial-type liquid smell or the scent of windshield washer fluid, it's another sign that it's been submerged in water.
A circuit that is wet can cause the battery's charge to drain or even explode. If you can pull your keyfob 308 out of the water you need to turn the button side up and shake as much water as possible before opening the casing. Once you have opened it, take out the battery, and then clean the circuit board using an alcohol-soaked cotton swab. 90-percent isopropyl alcohol.
Other reasons why your peugeot 3008 key programming 308 remote entry keyless system may not function include a dead battery in the coin-cell, receiver module problems signal interference, or a malfunctioning chip. If none of the above are the problem you can restart the system by disconnecting 12 volt battery from the car for 15 mins.
Dead Coin Battery
Peugeot cars are equipped with a remote start system that allows drivers to start their car from the distance, allowing them to warm up or cool down the car prior to entering. This feature is extremely beneficial particularly during the cold winter months. Remote start systems can cease to function for a variety reasons, such as a dead coin-battery.
A coin-shaped battery that is found inside the key fob will last a time of two to four years, based on how often used and where it is purchased. The date of use will be printed on the packaging or mentioned in the user manual.
If the key fob stopped functioning after being exposed to clean tapwater, remove the battery and clean the electronic chip with an absorbent paper towel that has been soaked in isopropyl ethanol. Then dry the chip thoroughly before replacing. If exposed to soapy or salty water, the chip could be damaged and you'll need to replace the key fob altogether.
If you're not certain the battery is defective, you can test its voltage with a multimeter that is set to the vehicle's voltage range and connected to the terminals for minus and plus. The voltage should be around 12-13 volts but if it is lower, the battery needs to be replaced. Alternatively, you can try to reset the on-board computer by disconnecting the battery with 12 volts for a couple of minutes, and then reconnecting it in reverse order (positive cable first, then negative). The engine should start after this.
Faulty Receiver Module
If you're unable to see the "Key Detected" message on your dashboard, it's possible the receiver module has created a fault. It's the part that transmits a signal to the car when the key fob is activated which acts as an immobiliser. It stops it from starting unless the correct key is in place.
This could be due to a variety of causes, such as water damage or simply aging. If the electronic chip within your peugeot 107 spare key, the original source, 308 keyfob is damaged by dirty tap water it could be because the keyfob was in contact with it. In this instance you'll need to remove off the battery and thoroughly clean it with isopropyl or electronic cleaner. When the battery is clean, you can try again.
If the issue persists, it is a good idea to visit a local Peugeot expert or locksmith. They'll be able to utilize a diagnostic tool to assist in identifying the problem and repair it for you.
It can be a stressful experience to lose your peugeot partner key fob programming car key. A certified auto locksmith can solve the issue in a matter of minutes. They can program your vehicle and cut a new, working key for you. Click here to locate a locksmith in your area.
Faulty Electronic Chip
The electronic chip in the Peugeot 308 key fob is a critical function in the remote control system. If it is damaged your car might not start or you might receive a message that reads "anti-theft active". In this case the only option is to replace the key. Fortunately, professional auto locksmiths are able to provide this service within the shortest period of time.
The chip inside the key fob of your peugeot partner key fob 308 could be damaged due to various reasons, such as sweat, water damage or dirt. If your Peugeot 308 key fob is exposed to soapy water, you should take it to the cleaners immediately. You can clean the electronic component with paper towels soaked with isopropyl Alcohol. The battery must then be allowed to dry completely.
Sometimes, a key fob can not function due to radio interference. This can be caused when other devices operate on the same frequency as your Peugeot keyfob. It could also be caused by bad weather or objects that are in the vicinity of the vehicle. If you experience this issue you should visit the Peugeot dealership.
The Peugeot Key Fob 207/308 is fragile and requires special attention. It should not be dropped or throw it around. If you lose it, try to find it as quickly as you can. You can reset your on-board computer by disconnection of the battery for a couple of minutes. Be sure to disconnect the negative cable first, and then the positive.